Open: Grip handle and turn lid counter-clock-wise until symbol on lid is aligned with symbol on rim of cooker base. Lower lid into track, then turn lid clockwise until symbol on the lid lines up *Note: Always check lid for damage prior to cooking.Ĭlose: Grip handle and align the symbol on lid with on rim of cooker base. Remove: Pull sealing ring out from behind sealing ring rack. It should be centered in the lid and an even height all the way around. Sealing ring must be installed before use. Install: Place sealing ring over sealing ring rack and press into place. Ensure entire sealing ring is snug behind sealing ring rack.Īfter closing the lid, the sealing ring creates an airtight seal between lid and cooker base. The sealing ring is an integral part of product safety.
Replace your sealing ring every 12-18 months or when deformation or damage is noticed.Īlways check for cuts or deformations in sealing ring prior to cooking. Only use authorized Instant Pot® sealing rings. Failure to follow these instructions may cause food to discharge, which may lead to personal injury or property damage. Do not use a stretched or damaged sealing ring. If puckering occurs, replace sealing ring. It pops up to indicate when the cooker is pressurized, and lowers into the lid when the cooker is depressurized. Refer to “Venting Methods” section in this Guide for information on releasing pressure. Remove: Place one finger on the flat top of float valve. Detach silicone cap from bottom side of float valve. Do not discard float valve or silicone cap. The float valve and silicone cap must be installed before use to seal in pressurized steam. Install: Drop float valve into float valve hole on top of lid. Place one finger on the flat top of float valve. Attach silicone cap to bottom of float valve. While float valve is up, contents of cooker are pressurized. Do not touch the float valve while the cooker is pressurized. Do not attempt to remove the lid while the cooker is pressurized. Remove: Grip lid and press firmly against side of anti-block shield (pressing towards side of lid and up) until it pops off the prongs underneath.Īnti-block shield must be installed before use and cleaned frequently. Install: Place anti-block shield over prongs and press down until it snaps into position.Īnti-block shield prevents food particles from coming up through the steam release pipe, assisting with pressure regulation. Remove: Pull steam release handle up and off steam release pipe. Steam release handle must be installed before use, and cleaned frequently. Install: Place steam release handle on steam release pipe and press down.
Playbackpro plus user guide 3.6 serial number#
PLAYBACKPRO PLUS 3.6 USER GUIDE SERIAL NUMBER.
0 kommentar(er)
